Az oldal korlátolt funkcionalitással fog rendelkezni, amíg elvégezzük a felhasználói élményt javító karbantartást. Ha egy leírás nem oldja meg a problémáját, és kérdést tenne fel, akkor a támogatási közösségünk a @FirefoxSupport Twitter oldalon tud segíteni, vagy az /r/firefox oldalon a Redditen.

Támogatás keresése

Kerülje el a támogatási csalásokat. Sosem kérjük arra, hogy hívjon fel egy telefonszámot vagy osszon meg személyes információkat. Jelentse a gyanús tevékenységeket a „Visszaélés bejelentése” lehetőséggel.

További tudnivalók

A témacsoportot lezárták és archiválták. Tegyen fel új kérdést, ha segítségre van szüksége.

Firefox 4 Menu Bar - When I hover over or select a menu bar item, the menu bar sub-menu becomes transparent and unreadable. Is this a known issue that can be corrected with an update or is it functionality that is not designed to work with this version?

  • 2 válasz
  • 19 embernek van ilyen problémája
  • 6 megtekintés
  • Utolsó üzenet ettől: lancelot2525

more options

Firefox 4 Menu Bar - When I hover over or select a menu bar item, the menu bar sub-menu becomes transparent and unreadable. Is this a known issue that can be corrected with an update or is it functionality that is not designed to work with this version?

Firefox 4 Menu Bar - When I hover over or select a menu bar item, the menu bar sub-menu becomes transparent and unreadable. Is this a known issue that can be corrected with an update or is it functionality that is not designed to work with this version?

Összes válasz (2)

more options

I stopped having this issue when I enabled the menu bar. Right-click on an empty section of the tab strip and put a check next to menu bar. It was even still working fine when I disabled the menu bar again later.

more options

If this happens on monitor 2 of 2, this problem has been solved here:

http://support.mozilla.com/en-US/questions/794823#answer-157988

Go to "Firefox"--> "Options" --> "Advanced" Then un-check "Use hardware acceleration when available"

While not verified, I believe this problem is due to an SLI configuration where the focus is on monitor 1. (I.e acceleration is available, but only on monitor 1.)